AEMC MR6292
AC/DC Current Probe for 6292 Micro-Ohmmeters, Lead Termination, 1A to 50A, 1.18 in./0.95 in.
MR6292
MR6292
AEMC MR6292
AC/DC Current Probe for 6292 Micro-Ohmmeters, Lead Termination, 1A to 50A, 1.18 in./0.95 in.
MR6292
MR6292
The AEMC MR6292 (2129.86) AC/DC Current Probe is an accessory for the AEMC 6292 Micro-Ohmmeters (not included). This probe is required for using the 6292 to take measurements in Both Sides Grounded (BSG) mode. The probe’s hook-shaped jaws enable the user to 'pry' into or 'hook' onto cables.
- Accepts two 500 MCM cables/small bus bars
- Utilizes Hall effect technology with electronics self-contained in handle
- Output of 10 mV/A
- No battery required
- Compatibility: 6292 Micro-Ohmmeters
- Required for utilizing Both Sides Grounded (BSG) mode for measurements on main unit
- Hook-shaped jaws enables user to pry/hook probe onto cable
- Accepts two 500 MCM cables/small bus bars
- Utilizes Hall effect technology
- All electronics self-contained within handle
- No battery required-- probe operates via voltage of main unit
- Proportional mV output for direct readings on main unit
- Measurement Range: 1 to 50ADC
- Accuracy: 1.5% reading +/- 0.2A at 1 to 50ADC
- Output Signal: 10 mV/ADC
- Load Impedance: More than 100 kOhms/100 pF
- Insertion Impedance: 0.39 mOhms at 50 Hz, 58 mOhms at 1000 Hz
- Working Voltage: 600Vrms
- Influence of Adjacent Conductor: Less than 10 mA/A at 50 Hz at 23 mm from probe
- Influence of Conductor in Jaw Opening: 0.5% reading
- Jaw Opening: 1.2 in. (31 mm)
- Maximum Cable Diameter: One 1.18 in. (30 mm)/two 0.95 in. (24 mm)/two bus bars 1.2 in. x 0.4 in. (31.5 mm x 10 mm)
- EN 61010-2-32, 600V CAT III, Pollution: 2
The AEMC MR6292 (2129.86) AC/DC Current Probe is an accessory for the AEMC 6292 Micro-Ohmmeters (not included). This probe is required for using the 6292 main unit to take measurements in Both Sides Grounded (BSG) mode.
The probe is designed to meet the latest safety and performance standards. The probe’s hook-shaped jaws enable the user to 'pry' into or 'hook' onto cables. This design accepts two 500 MCM cables or small bus bars.
The AEMC MR6292 (2129.86) uses Hall effect technology in which all electronics are self-contained in the handle. The output of the probe is 10 millivolts per amp. No battery is required as the probe operates via voltage provided by the 6292 main unit. The probe has a proportional millivolt output for direct reading on the 6292 main unit as well.
| Country of Origin | United States |
|---|---|
| Brand | AEMC |
| Condition | NEW |
- 1 - AC/DC Current Probe, 1.18 in./0.95 in. (MR6292)
- 1 - User Manual
