Fluke Calibration 9140-DW-156
Field Dry-Well Temperature Calibrator (No Insert), 35 °C to 350 °C
Fluke Calibration 9140-DW-156
Field Dry-Well Temperature Calibrator (No Insert), 35 °C to 350 °C
- Range: 35°C to 350°C (95°F to 662°F)
- Rapid heating and cooling
- Interchangeable multiple hole aluminum probe sleeves
- Range: 35°C to 350°C (95°F to 662°F)
- Rapid heating and cooling
- Interchangeable multiple hole aluminum probe sleeves
- Convenient hand strap
- RS-232 interface capability
- Temperature scan rate control
- Temperature switch hold
- Eight Setpoint memory
- Adjustable readout in °C or °F
The Fluke Calibration 9140DW156 Field Dry-Well Temperature Calibrator (No Insert), 35 °C to 350 °C may be used as a portable instrument or bench top temperature calibrator for calibrating thermocouple and RTD temperature probes. The 9140-DW-156 is small enough to use in the field, and accurate enough to use in the lab.
The temperature is accurately controlled by Hart's hybrid analog/digital controller. The controller uses a precision platinum RTD as a sensor and controls the well temperature with a solid state relay (triac) driven heater.
The LED front panel continuously shows the current well temperature. The temperature may be easily set with the control buttons to any desired temperature within the specified range. The instrument's multiple fault protection devices insure user and instrument safety and protection.
The 9140-DW-156 dry-well calibrator was designed for portability, low cost, and ease of operation. Through proper use the instrument will provide continued accurate calibration of temperature sensors and devices. The user should be familiar with the safety guidelines and operating procedures of the calibrator as described in the instruction manual.
Country of Origin | United States |
---|---|
Brand | Fluke Calibration |
Catalog | 3015854 |
Condition | NEW |
UPC | 095969413473 |
Vendor Alias | 9140-DW-156 |
- 1 - Power Cord
- 1 - 9930 Interface-it Software
- 1 - Serial Cable
- 1 - User Manual