Fluke T90
2-Pole Basic Voltage and Continuity Electrical Tester, AC/DC 12V to 690V
The Fluke T90 is a compact 2-Pole Basic Voltage and Continuity Electrical Tester that gives users fast test results in a slim design. It is the perfect basic tool to check the presence of voltage.
- Dual insulated cable tested to 3x required bend angle for increased reliability and durability
- Backlit graduated scale and indicators
- Continuity test with audible results
- Improved probe docking for secure storage
- Dual insulated cable tested to 3x the required bend angle provides increased reliability and durability
- Backlit graduated scale and backlit indicators
- Continuity test with audible results
- Improved probe docking for secure storage
- Single-pole phase test offers fast identification of live conductors
- Push-on probe tips, probe tip protector and storage accessory
- Low battery indicator
- Continuity test with visual results
- Voltage test
- Voltage detection with discharged batteries
- Wear indicator test lead wire
- Voltage AC/DC: 12V to 690V
- Continuity: 0 to 400 kΩ
- Frequency: 0 / 40 to 400 Hz
- Response time (LED indicator): < 0.5 s
- 200 kΩ input impedance: Current draw 3,5 mA @ 690 V / Current draw 1,15 mA @ 230 V
- Safety rating: CAT II 690V/CAT III 600V
- IP rating: IP54
- Power requirement: 2-AAA batteries
- Warranty: 2 years
The Fluke T90 2-Pole Basic Voltage and Continuity Electrical Tester, AC/DC 12V to 690V is a compact electrical tester that gives users fast test results in a slim design. This electrical tester has large, easy-to-use buttons, bright backlit LED indicators, and a clear audible indicator for quick results in any work situation. This voltage tester is the perfect basic tool to check the presence of voltage.
The T90 two-pole voltage and continuity tester measures voltage, but just as important is alerting users that there is NO voltage present before working on any circuit. Cable assemblies are often where failures occur. The cable on any two-pole voltage and continuity tester is its weakest point - it is repeatedly bent, twisted, wrapped and put under constant strain. If the cable were to break, it could place the user at an increased safety risk. Industry standards call for the cable to be tested to withstand a forty-five-degree bend, and still work after 5000 bend cycles. Fluke puts its testers through three times what the standard demands, flexing the cable over 150 degrees in each direction.
Country of Origin | United Kingdom |
---|---|
Catalog | 4016945 |
Vendor Alias | FLUKE-T90 |
Brand | Fluke |
Condition | NEW |
UPC | 095969599672 |
- 1 - 2-Pole Basic Voltage and Continuity Electrical Tester, AC/DC 12V to 690V