Hakko 375-01

Solder Feeder and Slicer, 0.5mm

37501
375-01

Hakko 375-01

Solder Feeder and Slicer, 0.5mm

37501
375-01

The Hakko 375-01 Solder Feeder and Slicer is a compact and space-saving automatic solder feeder which helps minimize solder splatter. The ON/OFF switch allows for the feeding amount of solder to be controlled while the v-groove slit applied to the solder surfaces reduces the splash of solder and flux by allowing gases to escape.

  • Solder Diameter: 0.5mm (0.020 in.)
  • Solder Feed Speed: 27mm/sec.
  • Rating: DC 24V/75mA
  • Motor Rating: DC 24V/130mA
$346.34 Price $364.57
This item ships FREE
  • Compact, space-saving automatic solder feeder
  • V-groove put on solder surface reduces the splash of solder and flux
  • Feeding amount of solder can be controlled by turning the switch ON/OFF

Hakko 375-01 Solder Feeder & Slicer (0.5 mm). To minimize solder spatter, specifically when soldering with lead-free solders, the Hakko 375 cuts a "slit" in the solder to allow the gases to escape.

As shown below, when solder is cut with a V-groove it enables the release of gas pressure generated by the flux, thereby suppressing splash. However, because the V-groove exposes the flux to outside air the solder cannot be stored for a long period of time. When using solder with the HAKKO 375, you can groove the solder that you require.

Five different models are available to cut solder wire diameters from 0.3 mm (0.020 inch) to 1.0 mm (0.039).

Can be applicable with the conventional solder reel stand. (HAKKO 611-1, HAKKO 611-2)

Use an option switch to increase efficiency: Control the amount of solder that is fed using the ON/OFF switch. Use an option switch or hand switch to increase functionality even more.

More Information
Country of OriginJapan
BrandHakko
ConditionNEW
Vendor Alias375-01
  • 1 - AC Adaptor
  • 1 - Instruction Manual