Hakko C5016

Bottom Heater for FR-811 Rework System

C5016
C5016

Hakko C5016

Bottom Heater for FR-811 Rework System

C5016
C5016
  • Integrates with FR-811 SMD hot air rework system
  • Fully controlled by FR-811 system
  • Can be operated in power or thermocouple mode
$808.97
This item ships FREE
  • Integrates with FR-811 SMD hot air rework system
  • Fully controlled by FR-811 system
  • Can be operated in power or thermocouple mode
  • Input Voltage: 120 VAC 50/60 Hz
  • Power Consumption: 730W
  • Effective Heater Area: 7.5 x 3.2 in. (190 x 80 mm)
  • Board Capacity: 9.8 x 5.5 in. (248 x 140 mm)
  • Heating Zones: 2
  • T/C Range: 122 to 482°F (50 to 250°C)
  • T/C Stability: ±9°F / ±5°C
  • Power Range: 1 - 100% (1% increments)
  • Heater Type: High Efficiency Carbon Filament
  • Heater Lamp MTBF: ~ 2100 hours
  • NOTE: Must be used with FR-811 System - will not work on its own or with any other units

The Hakko C5016 Bottom Heater for FR-811 Rework System integrates with and is fully controlled by the Hakko FR-811 SMD Rework System (sold separately) during the execution of user programmable rework profiles stored on the Hakko FR-811.

The Hakko C5016 has the same power and performance as the popular HAKKO FR-870B 2-Bank IR Preheater, and includes a left and right switchable zone.

Through the control provided by the Hakko FR-811 through included connecting cable, the C5016 Bottom Heater can operate in power or thermocouple modes just like the Hakko FR-870B, including the ability to monitor/control the ramp rate of the assembly. The thermocouple mode is controlled by the thermocouple input marked "B" on the face of the Hakko FR-811.

Note: The Hakko C5016 must be used with the FR-811. It will not work on its own or with any other units.

More Information
BrandHakko
ConditionNEW
  • 1 - C5016 Bottom Heater
  • 1 - B2419 Power Cord
  • 1 - Connecting Cable