GW Instek PEL-5024C-600-1680 single-channel electronic load provides 600V with a power range of 24kW. The PEL-5024C-600-1680 can test and verify the specifications of batteries, electric vehicle chargers/charging stations, electric vehicle batteries and solar panels. The PEL5024C6001680 supports parallel connection for same voltage specification and different power models. The PEL-5000C can support up to 8 units connected in parallel to provide a maximum power of 192kW.

DC Electronic Load

For the scenario of battery testing, PEL-5024C-600-1680 specifically provides four battery discharge modes, namely CC+CV battery discharge test mode, CP+CV battery discharge test mode, CC+ UVP battery discharge test mode, and CP+ UVP battery discharge test mode. Users can choose a suitable test mode according to the test requirements. In addition to the four battery discharge modes, PEL-5000C also provides Time period discharge, Pulse discharge, and RAMP discharge modes. Users can set the discharge time, or discharge in the pulse current mode, or even set the rising/falling slew rate of the discharge current. These functions can be very flexible in the simulation of the battery discharge current waveform when an electric vehicle is running.

In order to meet the verification requirements of different DUTs, PEL5024C6001680 provides a variety of test functions, including inrush current test mode, solar panel MPPT test mode, automated OCP, OPP test functions and 150 sets of parameter storage function. High-voltage batteries or chargers directly connected to the electronic load may cause damage to the electronic load. PEL-5000C has a built-in slow starter, which not only protects the DC load, but also saves the user's installation cost and setting time for measurement.