PowerSight 5KVPSET

5K Voltage Probe Set with Hook Tips, 3-Pack

5KVPSET
5KVPSET

PowerSight 5KVPSET

5K Voltage Probe Set with Hook Tips, 3-Pack

5KVPSET
5KVPSET
  • Connect directly to 3 phase up to 5KV
  • Allows bypassing PTs (Potential Transformers)
  • Entire set comes in compact 19 x 10 x 5 inch Cordura soft carrying case
This product is available for shipping to the US, Canada, and Puerto Rico only.
$1,650.00
This item ships FREE
  • Connect directly to 3 phase up to 5KV
  • Allows bypassing PTs (Potential Transformers)
  • Entire set comes in compact 19 x 10 x 5 inch Cordura soft carrying case
  • Shepherd's hook for easy connection to medium voltage (1/4 inch inside diameter)
  • All connections are labeled and advisory labels are attached, for review each time the probes are used
  • Measure harmonics up to 900 Hz
  • For use exclusively with PowerSight line of Energy Analyzers
  • Note: It is recommended that installation and removal be done on a de-energized circuit

PowerSight provides its 5KVPSET 3 voltage probe set for connecting directly to 3 phase voltages up to 5 kilovolts for complete analysis.

Normally, professionals who wish to measure 4,160 volt lines need to locate an installed PT (potential transformer) and then connect to the low voltage output secondary of the PT. The PT ratio is entered into the PowerSight so that primary values are displayed. However, sometimes a convenient PT is not available or the measurement must bypass the PT to verify whether the metering circuit is correct.

The 5KVPSet allows direct connection between the primary voltage and to your PowerSight analyzer. The set comes in its own compact canvas carrying case.

Simply connect the outputs to your PowerSight analyzer and to ground. Enter a 100:1 input ratio into your PowerSight analyzer and then hook the probes onto the medium voltage.

The connection to the medium voltage is via a shepherd's hook that has a 1/4 inch inside diameter.

The 5KVPSET probes is purchased as a set of three voltage probes, including a carrying case.

Whenever possible, connect the probes to a de-energized circuit. First, connect the ground lead of each of the probes to a secure ground point.

More Information
BrandPowerSight
ConditionNEW
  • 1 - User Manual
  • 1 - Set of Hook Tips
  • 1 - Ground Clamp
  • 1 - Neutral Connector
  • 1 - Reduced Voltage Connector