Teledyne LeCroy PCF200

Probe Deskew and Calibration Fixture

PCF200
PCF200

Teledyne LeCroy PCF200

Probe Deskew and Calibration Fixture

PCF200
PCF200

The Teledyne LeCroy PCF200 Probe Deskew and Calibration Fixture provides multiple probe connectors for various kinds of probes. There are two circuits, depending on the type of probes that need to be calibrated. The upper circuit is for Solder-In (SI) and Quick-Connect (QC) probes. It can also be used for AT probes using the designated area to apply the probe tips.

  • SMA male connector Fast Edge input
  • SMA female connector output to AUX IN for 50-ohm termination
$706.43 Price $710.00
This item ships FREE
  • SMA male connector Fast Edge input
  • SMA female connector output to AUX IN for 50-ohm termination
  • Clip for connection of Solder-In probes
  • 2-pins header for connection of Square-Pin probes

The Teledyne LeCroy PCF200 provides multiple probe connectors for various kinds of probes. There are 2 circuits depending on the type of probes to be calibrated. The upper circuit is for Solder-In (SI) and Quick-Connect (QC) probes. This circuit can also be used for AT probes using the designated area to apply the probe tips. The lower circuit is for Square-Pin (SP) probes.

Probes are connected electrically in a single-ended arrangement: the positive (+) side of the probe must be connected to the signal trace, while the negative (-) side is connected to the ground plane.

More Information
BrandLeCroy
ConditionNEW
  • 1 - PCF200 Probe Deskew and Calibration Fixture