The Teledyne LeCroy T3PS100011P Single-Output Programmable High-Precision DC Power Supply has the low output noise (< 1.2 mVrms) and fast transient response characteristics (< 100 μs) of conventional linear power supplies. It also provides constant voltage and constant current priority output modes. Users can set the voltage and current rising/falling slew rates separately, and the delay time for the output to be turned on and off.

The T3PS100011P has four current levels and two voltage levels to provide users with high-precision measurements. The Data Logger function can be used for long-term measurement and recording of IoT devices, portable devices, wearable devices, and sensor components. Recorded data can be stored via USB interface.

In order to extend the use time of portable and wearable devices, manufacturers are not only committed to improving the operating efficiency of circuits, but also reducing standby power consumption as much as possible. In order to satisfy users' low-power measurement applications, T3PS100011P features current measurement resolutions (0.1 μA, 1 μA, 10 μA, 0.1 mA) and voltage measurement resolutions (0.1 mV, 1 mV) that provide power for portable devices and wearable devices.

The T3PS100011P is capable of measuring the subtle current changes of the DUT even when the device enters sleep or standby mode.

T3PS100011P provides a Test Sequence function that allows users to arbitrarily define output waveforms. Different waveform parameters such as rise/fall time can be directly set and edited remotely via computer, on the front panel, or with a CSV file. In addition, the OCP Delay function allows users to flexibly adjust the over-current protection parameters based on DUT requirements.

The T3PS100011P also supports temperature measurements using a K-Type Thermocouple. The temperature range can be measured from - 200 °C ~ +1372 °C. Its standard communication interfaces include USB, LAN, RS-232, and RS-485.