Triplett TEV300
Electric Vehicle Charger Test Kit, 230V/400V
TEV300
TEV300
Triplett TEV300
Electric Vehicle Charger Test Kit, 230V/400V
TEV300
TEV300
The Triplett TEV300 Electric Vehicle Charger Test Kit provides fundamental wiring testing for EV charging systems with LED GO/NO GO that indicates the status of the charger output socket.
- Different vehicle states can be simulated: Vehicle states are simulated with different resistances connected between CP/PE conductors
- Input Voltage: 230V/400V
- Measurement Category: CAT II 300 V
- Operating Temperature: -4°F to 104°F
- Provides fundamental wiring testing for EV charging systems with LED GO/NO GO indication
- Indicates status of charger output socket (vehicle side)
- LED Indication/Chart Provides simple socket inspection conditions
- Proximity Pilot (PP) State (Cable Simulation) - Simulates 20A current capability between PP/PE conductors
- Built-In Control Pilot (CP) State (Vehicle Simulation Switch - Different vehicle states can be simulated: Vehicle states are simulated with different resistances connected between CP/PE conductors
- CP Error “E” simulation: Simulate behavior of station when there is established short circuit between CP/PE
- Complies with EMC Directive (2014/30/EU), Low Voltage Directive (2014/35/EU), EN61010-1 standards
- Includes: (1) IEC62196-2 Type 1 female to male adaptor/converter, plus pouch case
- Input Voltage: 230V/400V
- Network Types: TN, TT
- Measurement Category: CAT II 300 V
- IP Rating: IP40
- Operating Temperature: -4F to 104F
- Input Voltage: UL1/N = 120 V, UL2/N = 120 V, UL1/L2 = 208 V, 60 Hz (three-phase system), UL1/N = 120 V, UL2/N = 120 V, UL1/L2 = 240 V, 60 Hz (single-phase system), ±10% voltage fluctuations from nominal
Control Pilot (CP) State (Vehicle Simulation)
Vehicle State: A- Electric vehicle not connected
- CP/PE Resistance: Open (∞)
- Vehicle State: ±12V at 1KHz
- Electric vehicle connected, not ready to charge
- CP/PE Resistance: 2.74 K
- Vehicle State: +9V/-12V at 1KHz
- Electric vehicle connected, ready to charge, ventilation not required
- CP/PE Resistance: 882Ω
- Vehicle State: +6V/-12 at 1KHz
- CP Error
- CP/PE Resistance: 0Ω
- Vehicle State: 0V
The Triplett TEV300 Electric Vehicle Charger Test Kit provides fundamental wiring testing for EV charging systems with LED GO/NO GO that indicates the status of the charger output socket. An LED indication chart provides simple socket inspection conditions and does not require a vehicle connected to it. The Proximity Pilot (PP) State (Cable Simulation) simulates 20A current capability between PP and PE conductors. A built-in Control Pilot (CP) State (Vehicle Simulation Switch) can simulate vehicle states with different resistances connected between CP and PE conductors. CP Error “E” simulates the behavior of the station when there is an established short circuit between CP and PE. Complies with EMC Directive (2014/30/EU), the Low Voltage Directive (2014/35/EU), and EN61010-1 standards.
| Brand | Triplett |
|---|---|
| Condition | NEW |
| UPC | 614395005474 |
| Vendor Alias | TEV300 |
- 1 - Type 1 Female-to-Male Adapter/Converter, IEC62196-2
- 1 - Pouch Case
