The Viavi SMARTIDPLUS-ACTIVEID-KIT offers the combination of SmartID Plus and ActiveIDs, which together make it easy to identify specific coax runs easy and tell users if the cable ends are connected or not. The SmartID Plus is connected close to the premises point of entry and ActiveIDs are connected at each location where a CPE device, like a set top box or cable modem, would be located. The ActiveIDs are labeled from 1 to 8 so techs can remember where each ActiveID is connected and allow them to quickly determine if any ActiveID is not found. If an ActiveID is not discovered, then the coax is either not connected or has greater than 15dB of attenuation or signal loss between the SmartID Plus and the ActiveID. If the ActiveID is displayed, then there is continuity between it and the SmartID Plus in the coax network.